We recently finished printing our phone stand. It was our first time using the Ultimaker 3 and Ultimaker 3 Extended. The print took about ten hours. My phone stand was different from my partner’s. Mine had a lot of excess material, that needed to be sanded down and cut of with a knife. In the end, it turned out fine. The charger needed to keep being repositioned, because it was too low to charge my phone. It was very difficult to get back out to reposition. In the end, my charger did get damaged, because we needed to use excess force to pry it out. We also managed to print out the plug, and after some sanding, it fit perfectly. Unfortunately, it ended up in a weird off white color.
Categories:
#3DPrintedPhoneStand: Finished Product!
April 3, 2019
More to Discover
